There have been several articles in the media recently (see for
here) in relation to ECan's lack of response to breaches of
water take consents.
In particular, there is a real focus on the non-compliance of
over 500 users (around 9% of all water consents held in Canterbury)
who do not have the required water-monitors in place. The Resource
Management (Measurement and Reporting of Water Takes) Regulations
2010 introduced a requirement on anyone with a resource consent to
take water at a rate greater than 5 litres per second to install a
water measuring device.
Who do the regulations apply to?
The water monitoring requirements do not apply to the
Takes of less than 5 litres per second;
Takes of geothermal or coastal water; or
Takes that are non-consumptive (where the same amount of water
is returned back into the same water body, at or near the location
from which it was taken, with no significant delay).
All other water takes of over 5 litres per second, regardless of
whether water monitoring is a condition of consent, require a
monitoring device to be installed.
These regulations have been in effect since 10 November 2010,
and all resource consents for water takes granted since then must
comply immediately. If your water consent was granted prior to 10
November 2010, compliance with the monitoring requirements depend
on the consented volume in the consent:
20 litres per second (l/s) or more – compliance was
required by 10 November 2012;
10 l/s up to 20 l/s – compliance was required by 10
November 2014; and
5 l/s up to 10 l/s – compliance is required by 10
What do the regulations require?
Once a monitor is installed, water taken must be measured, and
records kept. The regulations require continuous measurements with
daily records of volume taken. The records must include days when
no water is taken (recorded as 'zero') and be in a format
that is able to be audited. The records must then be provided to
the regional council which issued the resource consent.
Where to from here?
ECan have responded to the media comments by outlining that all
water-users not complying with the monitoring requirements have
been contacted, with enforcement action to be taken against anyone
who does not comply. The vast majority of users are now compliant
– with any remaining non-compliant users being followed up by
Once all water monitoring is in place, ECan will be in a
position to ensure compliance with consent conditions, including
ensuring water is not being taken when a river is on restriction,
non-compliance with recording requirements, or taking more water
than authorised by the resource consent.
The content of this article is intended to provide a general
guide to the subject matter. Specialist advice should be sought
about your specific circumstances.
To print this article, all you need is to be registered on Mondaq.com.
Click to Login as an existing user or Register so you can print this article.
We have set out some examples of how the MERCP Act impacts resource exploration and production, and what you need to do.
Some comments from our readers… “The articles are extremely timely and highly applicable” “I often find critical information not available elsewhere” “As in-house counsel, Mondaq’s service is of great value”
Register for Access and our Free Biweekly Alert for
This service is completely free. Access 250,000 archived articles from 100+ countries and get a personalised email twice a week covering developments (and yes, our lawyers like to think you’ve read our Disclaimer).